Cut for the light. Set to be kept.

Made-to-order rings from a two-bench atelier in the Jewelry District, Providence.

Book a consultation

It starts as a rock.

A rough diamond is an octahedron: eight faces and no fire. Roughly half of it will be cut away before it is a stone.

Fifty-seven facets, polished one at a time.

00/ 57facets

Every facet is polished at its own angle.

  • Tableflat, 56 percent of the width
  • Pavilion40.75 degrees, eight mains
  • Lower girdlesixteen, on the pavilion edge
  • Crown34.5 degrees, eight bezels
  • Star facetseight, around the table
  • Upper girdlesixteen, the last cut

Steer the light.

Diamond bends light harder than almost anything clear: 2.417, where window glass is 1.52. Past 24.4 degrees it cannot leave at all, so it bounces. Cutting is arranging those bounces.

Light arrives at
-
Bends to
-
Bounces inside
-
Turned through
-
Color spread
-

Then it is set.

Four claws of wire hold the stone. Each is filed to its own facet under a loupe, then pushed over the girdle one at a time, with nothing to hide behind.

Claws not yet drawn

Milgrain is the last thing.

A small knurled wheel rolls a row of beads along the edge of the setting. It softens the metal and takes a steady hand. Only after this is the ring done.

Beads 0 of 236

Start with the stone.

Cut
Metal
1.00 ct 6.5 mm across
Claws

Round brilliant, 1.00 ct, platinum 950, four claws

From $3,670

A lab-grown stone. An estimate, quoted properly at the consultation.

Book this design

By appointment, at the bench.

Where
Chestnut Street, Jewelry District, Providence, RI 02903. The door number comes with your confirmation.
When
Tuesday to Friday, 11 to 6. Saturday, 10 to 4. Closed Sunday and Monday.
Call
(401) 555-0138
Ring the bell
The door is locked between fittings, so the bell rings at the bench.
Book a consultation